How To Proceed With Troubleshooting

METER / GAUGE / DISPLAY: METER / GAUGE SYSTEM: HOW TO PROCEED WITH TROUBLESHOOTING

HINT
* Use these procedures to troubleshoot the meter/gauge system.
* *: Use the Techstream.

1. VEHICLE BROUGHT TO WORKSHOP

NEXT -- Continue to next step.

2. INSPECT BATTERY VOLTAGE

Standard voltage:

11 to 14 V

If the voltage is below 11 V, recharge or replace the battery before proceeding.

NEXT -- Continue to next step.

3. CHECK FOR DTC*

(a) Check for DTCs and note any codes that are output Reading and Clearing Diagnostic Trouble Codes.

(b) Clear the DTCs Reading and Clearing Diagnostic Trouble Codes.

(c) Recheck for DTCs. Based on the DTCs output above, try to force output of the same CAN communication system or meter/gauge system DTC by reproducing the symptoms indicated by the DTC.

Result





B -- Go to CAN COMMUNICATION SYSTEM How to Proceed With Troubleshooting

C -- Go to DIAGNOSTIC TROUBLE CODE CHART Meter / Gauge System
A -- Continue to next step.

4. PROBLEM SYMPTOMS TABLE

(a) Refer to Problem Symptoms Table Problem Symptoms Table.

Result





B -- Go to step 6
A -- Continue to next step.

5. OVERALL ANALYSIS AND TROUBLESHOOTING*

(a) Terminals of ECU Meter / Gauge System

(b) Data List / Active Test Meter / Gauge System

(c) Operation Check Operation Check

NEXT -- Continue to next step.

6. REPAIR OR REPLACE

NEXT -- Continue to next step.

7. CONFIRMATION TEST

NEXT -- END