Removal

HEATING / AIR CONDITIONING: AIR CONDITIONING AMPLIFIER: REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

2. REMOVE DOOR SCUFF PLATE ASSEMBLY RH

(a) Put protective tape around the door scuff plate.





Text in Illustration





(b) Using a screwdriver, detach the 4 clips, 10 claws and 2 guides and remove the door scuff plate.

HINT
Tape the screwdriver tip before use.

3. REMOVE COWL SIDE TRIM BOARD RH

(a) Remove the clip.





(b) Detach the clip and claw and remove the cowl side trim board.

4. REMOVE NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH

(a) Open the instrument cluster finish panel lid.

(b) Put protective tape around the No. 2 instrument cluster finish panel garnish.

(c) Grip the No. 2 instrument cluster finish panel garnish and pull it diagonally upward toward the rear to detach the 5 clips and remove the No. 2 instrument cluster finish panel garnish.





Text in Illustration





5. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Removal

6. REMOVE LOWER INSTRUMENT COVER LH Removal

7. REMOVE LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY Removal

8. REMOVE INSTRUMENT PANEL BOX DOOR COVER Removal

9. REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY Removal

10. REMOVE NO. 2 AIR DUCT SUB-ASSEMBLY Removal

11. REMOVE ECU INTEGRATION BOX RH





(a) Disconnect the connectors and detach the clamp.

(b) Remove the 2 nuts, bolt and ECU integration box RH.

12. REMOVE AIR CONDITIONING AMPLIFIER ASSEMBLY





(a) Detach the 2 claws and remove the air conditioning amplifier assembly.