Removal

1GR-FE FUEL: FUEL PUMP: REMOVAL

1. REMOVE FUEL TANK ASSEMBLY

(a) Remove the fuel tank assembly Removal.

2. REMOVE FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY

(a) Set the plate and claws of SST onto the fuel pump gauge retainer and temporarily tighten the bolts.





SST : 09808-14030

09808-01010

09808-01020

09808-01030

09808-01040

09808-01050

(b) While firmly pressing the claws of SST against the ribs of the retainer, fully tighten each bolt.

(c) Set SST handle in place.

(d) While pressing down tightly on SST to prevent it from rising up, slowly rotate the handle to loosen the retainer.





NOTICE:
* Pressing the retainer against the pump with excessive force will make it difficult to turn and may damage the parts, so do not press down too strongly on SST.
* Applying excessive force at an angle may cause SST to slip off, so be sure to keep the handle level while rotating.
* To avoid damaging the parts, do not turn the handle of SST too forcefully, and do not use an impact wrench.
* If SST slips off the retainer, stop turning the handle, loosen the bolts of SST, and perform the SST set procedure again.

(e) Remove the retainer.

(f) Remove the fuel suction with pump and gauge tube assembly from the fuel tank.

NOTICE:
Do not bend the arm of the sender gauge.

(g) Remove the gasket from the fuel tank.