Installation

WINDSHIELD / WINDOW GLASS: POWER WINDOW REGULATOR MOTOR: INSTALLATION

1. INSTALL POWER WINDOW REGULATOR MOTOR ASSEMBLY

(a) Apply MP grease to the sliding and rotating areas of the regulator motor.





(b) Using "Torx" socket wrench T25, install the power window regulator motor with the 3 screws.

Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)

2. INSTALL FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY Reassembly

3. INSTALL FRONT DOOR GLASS SUB-ASSEMBLY Reassembly

4. INSTALL FRONT DOOR WINDOW FRAME REAR LOWER Reassembly

5. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH Reassembly

6. INSTALL FRONT DOOR FRAME SUB-ASSEMBLY FRONT LOWER Reassembly

7. INSTALL FRONT DOOR GLASS RUN Reassembly

8. INSTALL FRONT DOOR WEATHERSTRIP Reassembly

9. INSTALL FRONT DOOR CHECK ASSEMBLY Reassembly

10. INSTALL FRONT DOOR INSIDE PANEL PLATE Reassembly

11. INSTALL FRONT DOOR SERVICE HOLE COVER Reassembly

12. INSTALL FRONT NO. 1 SPEAKER Installation

13. INSTALL FRONT DOOR GLASS OUTER WEATHERSTRIP ASSEMBLY Installation

14. INSTALL OUTER REAR VIEW MIRROR Installation

15. INSTALL FRONT NO. 2 DOOR SERVICE HOLE COVER Reassembly

16. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY Reassembly

17. INSTALL FRONT ARMREST BASE UPPER PANEL Reassembly

18. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque : 3.9 Nm (40 kgf-cm, 35 in-lbf)