Programming and Relearning

SLIDING ROOF: SLIDING ROOF SYSTEM: INITIALIZATION

1. INITIALIZE SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY

NOTICE:
Be sure to initialize the sliding roof drive gear (pulse sensor) after adjusting the sliding roof glass position or removing and installing components. Without initialization, there may be a malfunction in the sliding roof auto operation, or key-off operation.

If any of the following conditions occurs during initialization procedure, initialization will fail.

* The ignition switch is turned off.
* Communication is cut off.
* Another switch is turned on during initialization.
* Vehicle speed is 5 km/h (3 mph) or more.
* The vehicle experiences a strong vibration during initialization, such as the slamming of a door.

(a) Initialization

HINT
According to the following chart, proceed to the appropriate initialization procedure.





(1) [A] The sliding roof AUTO function does not operate.

Turn the ignition switch on (IG). *1

Fully close the sliding roof.

Press and hold the sliding roof switch (TILT UP side) until the following movement finishes: Tilt up -> stationary state for at least 1 second -> tilt down -> slide open -> slide close.

NOTICE:
Press and hold the sliding roof switch (TILT UP side) until step *2 is complete. If the switch is released before step *2 is complete, restart from step *1.

Confirm that the roof glass is stopped at the fully closed position and initialization is completed. *2

(2) [B] Although the sliding roof AUTO function operates, the roof glass stops moving or starts moving in the opposite direction while tilting downward.

Turn the ignition switch on (IG). *1

Press and hold the sliding roof switch (TILT UP side) until the sliding roof stops.

After the sliding roof stops, release the switch.

Press and hold the sliding roof switch (TILT UP side) for more than 10 seconds until the following movement finishes: Tilt up -> stationary state for at least 1 second -> tilt down -> slide open -> slide close.

NOTICE:
Press and hold the sliding roof switch (TILT UP side) until step *2 is complete. If the switch is released before step *2 is complete, restart from step *1.

Confirm that the roof glass is stopped at the fully closed position and initialization is complete. *2

Confirm that the sliding roof can be normally operated with the AUTO function.

(3) [C] Although the sliding roof AUTO function operates, the roof glass stops moving or starts moving in the opposite direction while sliding closed.

Turn the ignition switch on (IG). *1

Press and hold sliding roof switch (TILT UP side) until the following movement finishes: Slide close -> roof glass stops moving or starts moving in the opposite direction -> stationary for at least 10 seconds -> slide close.

NOTICE:
Press and hold sliding roof switch (TILT UP side) until step *2 is complete. If the switch is released before step *2 is complete, restart from step *1.

After the sliding roof has stopped at the fully closed position, release the switch. *2

Follow the initialization procedure described in [A] (The sliding roof AUTO function does not function.)