Removal
2GR-FXE LUBRICATION: OIL PUMP: REMOVAL
1. REMOVE ENGINE ASSEMBLY
Removal
2. INSTALL ENGINE TO ENGINE STAND Removal
3. REMOVE V-RIBBED BELT Removal
4. REMOVE ELECTRIC INVERTER COMPRESSOR ASSEMBLY Removal
5. REMOVE ENGINE WIRE Removal
6. REMOVE ENGINE MOUNTING BRACKET RH Removal
7. REMOVE EGR DELIVERY CHAMBER Removal
8. REMOVE IGNITION COIL ASSEMBLY Removal
9. REMOVE PURGE VSV
(a) Remove the bolt and purge VSV.
10. REMOVE NO. 8 WATER BY-PASS HOSE
(a) Remove the No. 8 water by-pass hose from the inlet water pipe.
11. REMOVE NO. 2 ENGINE MOUNTING STAY RH Removal
12. REMOVE NO. 2 TIMING GEAR COVER Removal
13. REMOVE FRONT NO. 1 ENGINE MOUNTING BRACKET LH Disassembly
14. REMOVE V-RIBBED BELT TENSIONER ASSEMBLY Removal
15. REMOVE NO. 1 OIL PIPE Disassembly
16. REMOVE OIL PIPE Disassembly
17. REMOVE WATER INLET HOUSING
(a) Disconnect the No. 1 water by-pass hose from the water inlet housing.
(b) Disconnect the water hose.
(c) Remove the 2 bolts, nut and water inlet housing.
Text in Illustration
(d) Remove the gasket and O-ring.
18. REMOVE CYLINDER HEAD COVER SUB-ASSEMBLY Disassembly
19. REMOVE CYLINDER HEAD COVER SUB-ASSEMBLY LH Disassembly
20. REMOVE OIL COOLER PIPE
(a) Remove the 2 bolts, 4 nuts and oil cooler pipe.
(b) Remove the 2 gaskets.
21. REMOVE NO. 2 OIL PAN SUB-ASSEMBLY Disassembly
22. REMOVE OIL STRAINER SUB-ASSEMBLY Disassembly
23. REMOVE OIL PAN SUB-ASSEMBLY Disassembly
24. REMOVE CRANKSHAFT PULLEY Removal
25. REMOVE TIMING CHAIN COVER SUB-ASSEMBLY
(a) Remove the 23 bolts and 2 nuts shown in the illustration.
Text in Illustration
(b) Remove the timing chain cover by prying between the timing chain cover and cylinder head or cylinder block with a screwdriver.
Text in Illustration
NOTICE:
Be careful not to damage the contact surfaces of the cylinder head, cylinder block and chain cover.
HINT
Tape the screwdriver tip before use.
(c) Remove the gasket.
26. REMOVE TIMING CHAIN COVER OIL SEAL
(a) Using a screwdriver, pry out the oil seal.
Text in Illustration
NOTICE:
Do not damage the surface of the oil seal press fit hole.
HINT
Tape the screwdriver tip before use.