Fuel Injector: Testing and Inspection

2GR-FXE FUEL: FUEL INJECTOR: INSPECTION

1. INSPECT FUEL INJECTOR ASSEMBLY

(a) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





If the result is not as specified, replace the fuel injector assembly.

(b) Inspect the injection volume.

CAUTION:
This test involves high-pressure fuel and electricity. Take all precautions regarding safe handling of both the fuel and the electricity. Perform this test in a safe area and avoid any sparks or flames. Do not smoke.





(1) Connect SST to the fuel filter.

SST : 09268-31012

09268-41500

90467-13001

95336-08070

Text in Illustration





(2) Install the O-ring to the fuel injector.





(3) Install SST and a tube to the fuel injector.

SST : 09268-31012

09268-41140

09268-41400

90467-13001

95336-08070

Text in Illustration





(4) Put the injector into a graduated cylinder.

CAUTION:
Install a strong rubber tube to the injector to prevent gasoline from splashing.

(5) Operate the fuel pump Fuel System.

(6) Connect SST (wire) to the injector assembly and battery for 15 seconds and measure the injection volume with the graduated cylinder. Test each injector 2 or 3 times.





SST : 09842-30080

Standard injection volume:

76 to 91 cc (4.6 to 5.6 cu.in.) every 15 seconds

Difference between each injector:

15 cc (0.9 cu.in.) or less

Text in Illustration





NOTICE:
Always switch the voltage on and off at the battery, not at the injector.

If the injection volume is not as specified, replace the injector assembly.

(c) Check for leakage.

(1) Disconnect the tester probes of SST (wire) from the battery and check for fuel leaks from the injector.

Standard fuel leakage:

1 drop or less every 34 minutes