Removal

2GR-FXE ENGINE CONTROL SYSTEM: ECM: REMOVAL

1. REMOVE DECK BOARD ASSEMBLY Removal

2. REMOVE BATTERY SERVICE HOLE COVER ASSEMBLY Removal

3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

4. REMOVE ECM

(a) Disconnect the 2 ECM connectors and wire harness clamp.

(1) Push in the locks on the 2 levers, raise the levers, and disconnect the 2 ECM connectors.





NOTICE:
After disconnecting the connectors, make sure that dirt, water or other foreign matter does not contact the connecting part of the connectors.

(2) Disconnect the 3 wire harness clamps.





(3) Detach the clamp and disconnect the cooler pipe as shown in the illustration.





(4) Remove the 3 bolts and ECM with bracket.





NOTICE:
Do not deform the cooler pipe when moving it to access the bolts on the lower side.

(b) Remove the 2 bolts and wire harness bracket.





(c) Remove the 4 bolts, No. 1 ECM bracket and No. 2 ECM bracket.





(d) Detach the 3 claws and remove the engine room ECM cover and ECM.