How to Proceed With Troubleshooting

TIRE AND WHEEL: TIRE PRESSURE WARNING SYSTEM: HOW TO PROCEED WITH TROUBLESHOOTING

HINT
* Use the following procedures to troubleshoot the tire pressure warning system.
* *: Use the Techstream.

1. VEHICLE BROUGHT TO WORKSHOP

NEXT -- Continue to next step.

2. CUSTOMER PROBLEM ANALYSIS

(a) Interview the customer to confirm the trouble.

HINT
It is important to collect as much specific information as possible from the customer to allow for a quick repair.

NEXT -- Continue to next step.

3. ADJUST TIRE PRESSURE

(a) Turn the ignition switch off.

(b) Connect the Techstream to the DLC3.

(c) Turn the ignition switch to ON and turn the Techstream on.

(d) Enter the following menus: Chassis / Tire Pressure Monitor / Data List.

(e) Read the "ID Tire Inflation Pressure" values.

(f) Adjust all tire pressures to the standard values Service Precautions.

(g) Check the DATA LIST Data List / Active Test.

HINT
* It takes about 2 or 3 minutes to display the updated tire pressure data.
* If the problem is that the tire pressure decreases, wait until all of the tire pressure data is received by the ECU. If the data is received, the tire pressure warning light will turn off.

Result





B -- GO TO STEP 11
A -- Continue to next step.

4. CHECK ECU CONNECTED TO CAN BUS*

(a) Check the ECUs connected to the CAN bus Diagnosis System for w/ Smart Key System, Diagnosis System for w/o Smart Key System).

Result





B -- Go to CAN COMMUNICATION SYSTEM
A -- Continue to next step.

5. CHECK FOR DTC*

(a) Check for DTCs Reading and Clearing Diagnostic Trouble Codes.

Result





B -- GO TO STEP 8
A -- Continue to next step.

6. DTC CHART

(a) Refer to DIAGNOSTIC TROUBLE CODE CHART Tire Pressure Warning System.

NEXT -- GO TO STEP 10

7. PROBLEM SYMPTOMS TABLE

(a) Refer to PROBLEM SYMPTOMS TABLE Symptom Related Diagnostic Procedures.

NEXT -- Continue to next step.

8. CIRCUIT INSPECTION*

(a) Refer to ELECTRONIC CIRCUIT INSPECTION PROCEDURE Electronic Circuit Inspection Procedure.

NEXT -- Continue to next step.

9. REPAIR OR REPLACE

(a) Repair or replace parts based on the diagnosis result.

NEXT -- Continue to next step.

10. CONFIRMATION TEST

(a) Check the DATA LIST to confirm that the tire inflation pressure has been received Data List / Active Test.

NEXT -- END