Installation

3UR-FE STARTING: STARTER: INSTALLATION

1. INSTALL STARTER ASSEMBLY

(a) Install the flywheel housing side cover.





(b) Install the starter with the 2 bolts.





Torque : 37 Nm (377 kgf-cm, 27 ft-lbf)

(c) Install the starter wire with the nut.





Torque : 9.8 Nm (100 kgf-cm, 87 in-lbf)

(d) Connect the starter connector.

2. INSTALL STARTER COVER

(a) Install the starter cover with the 3 bolts.





Torque : 12 Nm (122 kgf-cm, 9 ft-lbf)

3. INSTALL EXHAUST MANIFOLD SUB-ASSEMBLY RH Installation

4. INSTALL NO. 1 EXHAUST MANIFOLD HEAT INSULATOR Installation

5. INSTALL NO. 1 MANIFOLD STAY Installation

6. INSTALL FRONT EXHAUST PIPE ASSEMBLY Installation

7. INSTALL CENTER EXHAUST PIPE ASSEMBLY Installation

8. INSTALL TAILPIPE ASSEMBLY Installation

9. INSTALL ENGINE OIL LEVEL DIPSTICK GUIDE Installation

10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

11. INSPECT FOR EXHAUST GAS LEAK Installation

12. INSTALL NO. 2 ENGINE UNDER COVER Installation

13. INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY Installation

14. INSTALL FRONT FENDER APRON SEAL REAR RH Installation

15. INSTALL FRONT FENDER APRON SEAL FRONT RH Installation

16. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH Installation

17. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH Installation