Front Passenger Side Power Window Does Not Operate With Front Passenger Side Power Window Switch

WINDOW / GLASS: POWER WINDOW CONTROL SYSTEM: Front Passenger Side Power Window does not Operate with Front Passenger Side Power Window Switch
- Front Passenger Side Power Window does not Operate with Front Passenger Side Power Window Switch

DESCRIPTION

* If the manual up/down function does not operate, there may be a malfunction in the power window regulator switch, front power window regulator motor RH, harness or connector.

WIRING DIAGRAM





INSPECTION PROCEDURE

PROCEDURE

1. CHECK LIN COMMUNICATION SYSTEM

(a) Check for LIN communication system DTCs related to the power window control system Reading and Clearing Diagnostic Trouble Codes.

OK:

LIN communication system DTCs are not output.

NG -- GO TO LIN COMMUNICATION SYSTEM LIN Communication System
OK -- Continue to next step.

2. CHECK FOR DTC (B2312)

(a) Check if DTC B2312 is output Reading and Clearing Diagnostic Trouble Codes.

OK:

DTC B2312 is not output.

NG -- GO TO DTC B2312 B2312
OK -- Continue to next step.

3. READ VALUE USING TECHSTREAM (FRONT POWER WINDOW REGULATOR MOTOR RH)

(a) Use the Data List to check if the power window regulator motor is functioning properly Scan Tool Testing and Procedures.

P-Door Motor





OK:

The Techstream display changes according to operation of the power window regulator switch.

NG -- CHECK HARNESS AND CONNECTOR (POWER WINDOW REGULATOR SWITCH - BODY GROUND)

OK -- REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY RH Removal

4. CHECK HARNESS AND CONNECTOR (POWER WINDOW REGULATOR SWITCH - BODY GROUND)

(a) Disconnect the I3 switch connector.





(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.

5. CHECK HARNESS AND CONNECTOR (FRONT POWER WINDOW REGULATOR MOTOR RH - BATTERY AND BODY GROUND)





(a) Disconnect the I4 motor connector.

(b) Measure the voltage and resistance according to the value(s) in the table below.

Standard Voltage:





Standard Resistance:





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.

6. CHECK HARNESS AND CONNECTOR (POWER WINDOW REGULATOR SWITCH - FRONT POWER WINDOW REGULATOR MOTOR RH)

(a) Disconnect the I3 switch connector.





(b) Disconnect the I4 motor connector.

(c) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.

7. INSPECT POWER WINDOW REGULATOR SWITCH





(a) Remove the power window regulator switch Removal.

(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





NG -- REPLACE POWER WINDOW REGULATOR SWITCH ASSEMBLY Removal

OK -- REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY RH Removal