Removal

WINDOW / GLASS: POWER WINDOW REGULATOR MOTOR (for Rear Door): REMOVAL

HINT
* Use the same procedures for the LH side and RH side.
* The procedures listed below are for the LH side.

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

2. REMOVE REAR DOOR INSIDE HANDLE BEZEL Disassembly

3. REMOVE REAR DOOR ARMREST BASE PANEL ASSEMBLY Removal

4. REMOVE ASSIST GRIP COVER Disassembly

5. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY Disassembly

6. REMOVE REAR INNER DOOR GLASS WEATHERSTRIP Disassembly

7. REMOVE REAR SPEAKER SET Removal

8. REMOVE REAR DOOR SERVICE HOLE COVER Disassembly

9. REMOVE REAR DOOR GLASS RUN Disassembly

10. REMOVE REAR DOOR REAR LOWER WINDOW FRAME SUB-ASSEMBLY Disassembly

11. REMOVE REAR DOOR QUARTER WINDOW GLASS Disassembly

12. REMOVE REAR DOOR GLASS SUB-ASSEMBLY Disassembly

13. REMOVE REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY Disassembly

14. REMOVE REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY

(a) Using a T25 "TORX" driver, remove the 3 screws and motor.





NOTICE:
Be careful when removing the screws as the motor may fall and become damaged.