Operation CHARM: Car repair manuals for everyone.
Home >> Toyota Truck >> 2011 >> Sequoia 4WD V8-4.6L (1UR-FE) >> Repair and Diagnosis >> Restraints and Safety Systems >> Relays and Modules - Restraints and Safety Systems >> Air Bag Control Module >> Service and Repair >> Installation

Installation





SUPPLEMENTAL RESTRAINT SYSTEMS: CENTER AIRBAG SENSOR ASSEMBLY: INSTALLATION

CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing Service Precautions.

1. INSTALL AIRBAG SENSOR ASSEMBLY





(a) Confirm that the ignition switch is turned off.

(b) Confirm that the negative battery terminal is disconnected.

CAUTION:
* Confirm that the negative battery terminal is disconnected before performing the operation. Even an impact to only the airbag sensor will cause the airbag to deploy.
* Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
(c) Install the airbag sensor with the 3 bolts.

Torque : 18 Nm (184 kgf-cm, 13 ft-lbf)

NOTICE:
* Do not use an airbag sensor that has been dropped.
* Do not subject the airbag sensor to any impact or force.
* Confirm that the carpet does not interfere with the installation plane.

(d) Confirm that there is no looseness by shaking the front airbag sensor.

(e) Connect the connector holder to lock the lever.





NOTICE:
Confirm that the lever is locked.

(f) Confirm that the drip-proof sheet has not been removed and does not cut into the connectors.

2. INSTALL FRONT CONSOLE BOX Installation

3. INSTALL REAR CONSOLE BOX ASSEMBLY Installation

4. INSTALL CONSOLE BOX CARPET Installation

5. INSTALL REAR CONSOLE BOX POCKET Installation

6. INSTALL REAR UPPER CONSOLE PANEL SUB-ASSEMBLY Installation

7. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY Installation

8. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY Installation

9. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH Installation

10. INSTALL HOOD LOCK CONTROL LEVER SUB-ASSEMBLY Installation

11. INSTALL INSTRUMENT SIDE PANEL LH Installation

12. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH Installation

13. INSTALL FRONT PILLAR GARNISH LH Installation

14. INSTALL COWL SIDE TRIM BOARD LH Installation

15. INSTALL FRONT DOOR SCUFF PLATE LH Installation

16. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)

17. INSPECT SRS WARNING LIGHT

(a) Inspect the SRS warning light Diagnosis System.
pro multis · About Operation CHARM