Installation

SUPPLEMENTAL RESTRAINT SYSTEMS: OCCUPANT CLASSIFICATION ECU: INSTALLATION

CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing Service Precautions.

1. INSTALL OCCUPANT CLASSIFICATION ECU (for Manual Seat)

(a) Check that the ignition switch is off.

(b) Check that the negative battery (-) terminal is disconnected.

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

(c) Engage the claw and occupant classification ECU.

(d) Connect the 2 connectors to the occupant classification ECU.

NOTICE:
* If the occupant classification ECU has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.
* When installing the occupant classification ECU, make sure that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.
* When replacing the occupant classification ECU, replace the bolt with a new one.

3. INSTALL FRONT SEAT ASSEMBLY RH (for Manual Seat)

(a) Install the front seat assembly RH Installation.

4. INSTALL FRONT SEAT ASSEMBLY RH (for Power Seat)

(a) Install the front seat assembly RH Installation.

5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)

6. INSPECT SRS WARNING LIGHT

Diagnosis System