Front Passenger Side Power Window Does Not Operate With Front Passenger Side Power Window Switch

WINDOW / GLASS: POWER WINDOW CONTROL SYSTEM: Front Passenger Side Power Window does not Operate with Front Passenger Side Power Window Switch
- Front Passenger Side Power Window does not Operate with Front Passenger Side Power Window Switch

DESCRIPTION

* If the manual UP/DOWN function does not operate, there may be a malfunction in the power window regulator switch, the front power window regulator motor RH, the harness and connector.

WIRING DIAGRAM





INSPECTION PROCEDURE

PROCEDURE

1. CHECK LIN COMMUNICATION SYSTEM

(a) Check for LIN communication system DTCs related to the power window control system Reading and Clearing Diagnostic Trouble Codes.

OK:

LIN communication system DTCs are not output.

NG -- GO TO LIN COMMUNICATION SYSTEM LIN Communication System
OK -- Continue to next step.

2. CHECK DTC (B2312)

(a) Check if DTC B2312 is output Reading and Clearing Diagnostic Trouble Codes.

OK:

DTC B2312 is not output.

NG -- GO TO DTC (B2312) B2312
OK -- Continue to next step.

3. READ VALUE USING TECHSTREAM (P-DOOR MOTOR)

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / P-Door Motor / Data List.

(e) According to the display on the Techstream, read the Data List.

P-Door Motor





OK:

The Techstream display changes normally when front passenger side power window switch is operated.

NG -- CHECK HARNESS AND CONNECTOR (FRONT POWER WINDOW REGULATOR SWITCH RH - BODY GROUND)

OK -- REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY RH Removal

4. CHECK HARNESS AND CONNECTOR (FRONT POWER WINDOW REGULATOR SWITCH RH - BODY GROUND)

(a) Disconnect the L2 Front power window regulator switch assembly RH connector.





(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





(c) Reconnect the Front power window regulator switch assembly connector.

NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.

5. CHECK HARNESS AND CONNECTOR (FRONT P/W REGULATOR MOTOR RH - BATTERY, BODY GROUND)

(a) Disconnect the L3 front power window regulator motor assembly RH connector.





(b) Measure the voltage and resistance according to the value(s) in the table below.

Standard Voltage:





Standard Resistance:





(c) Reconnect the front power window regulator motor assembly RH connector.

NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.

6. CHECK HARNESS AND CONNECTOR (FRONT POWER WINDOW SWITCH RH - FRONT POWER WINDOW MOTOR RH)

(a) Disconnect the L2 front power window regulator switch assembly RH connector.





(b) Disconnect the L3 front power window regulator motor assembly RH connector.

(c) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





(d) Reconnect the front power window regulator motor assembly RH connector.

(e) Reconnect the front power window regulator switch assembly RH connector.

NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.

7. INSPECT FRONT POWER WINDOW REGULATOR SWITCH ASSEMBLY RH

(a) Remove the front power window regulator switch assembly RH Removal.





(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





(c) Reinstall the front power window regulator switch assembly RH.

NG -- REPLACE FRONT POWER WINDOW REGULATOR SWITCH ASSEMBLY RH Removal

OK -- REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY RH Removal