Vehicle Stability Control System

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: VEHICLE STABILITY CONTROL SYSTEM: DIAGNOSTIC TROUBLE CODE CHART

NOTICE:
When removing any parts, turn the ignition switch off.

HINT
* If no abnormality is found when inspecting parts, check the skid control ECU and check for poor contact at ground points.
* If a trouble code is displayed during the DTC check, inspect the trouble areas listed for that code. For details of the code, refer to "See page" below.
* When 2 or more DTCs are detected, perform each circuit inspection until the problem is identified.
* All DTCs in the table below are detected in accordance with 1 trip detection logic.

DTC Chart of ABS

HINT
Even after the trouble areas are repaired, the ABS warning light will not go off unless the following operations are performed.

(a) Drive the vehicle at 20 km/h (12 mph) for 30 seconds or more and check that the ABS warning light goes off.
(b) Clear the DTC(s).

DTC Chart of VSC

Test Mode DTC of ABS