ECU Power Source Circuit

THEFT DETERRENT / KEYLESS ENTRY: ENGINE IMMOBILISER SYSTEM (w/o Smart Key System): ECU Power Source Circuit
- ECU Power Source Circuit

DESCRIPTION

This circuit provides power to operate the transponder key ECU.

WIRING DIAGRAM





INSPECTION PROCEDURE

NOTICE:
* If the transponder key ECU is replaced, register the key and ECU communication ID Engine Immobiliser System (w/o Smart Key System).
* Inspect the fuses for circuits related to this system before performing the following inspection procedure.

PROCEDURE

1. CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - BATTERY AND BODY GROUND)

(a) Disconnect the D47 transponder key ECU connector.





(b) Measure the voltage and resistance according to the value(s) in the table below.

Standard Voltage:





Standard Resistance:





Text in Illustration





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR, OR REPLACE FUSE

OK -- PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Engine Immobiliser System (w/o Smart Key System)