Smart Key System (for Start Function)

THEFT DETERRENT / KEYLESS ENTRY: SMART KEY SYSTEM (for Start Function): DATA LIST / ACTIVE TEST

1. DATA LIST

HINT
Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

(a) Connect the Techstream to the DLC3.

(b) Turn the engine switch on (IG).

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / Power Source Control / Data List.

(e) According to the display on the Techstream, read the Data List.

Power Source Control

















HINT
Get into the vehicle while carrying the key. With the engine switch off and the shift lever in P, perform the following procedures and check the power source mode.

*1: Without depressing the brake pedal, press the engine switch and check that the power source mode turns on (ACC).

*2: Without depressing the brake pedal, press the engine switch and check that the power source mode turns on (IG).

*3: Depress the brake pedal (the stop light switch turns on).

*4: With the brake pedal depressed, press the engine switch and check that the engine starts.

*5: Press the engine switch and check that the power source mode turns off.

*6: Release the brake pedal.

*7: Open a door.

(f) Enter the following menus: Body Electrical / Smart Key / Data List.

(g) According to the display on the Techstream, read the Data List.

Smart Key

















HINT
Get into the vehicle while carrying the key. With the engine switch off, the shift lever in P and all the doors closed, perform the following procedures and check the power source mode.

*1: Without depressing the brake pedal, press the engine switch and check that the power source mode turns on (ACC).

*2: Without depressing the brake pedal, press the engine switch and check that the power source mode turns on (IG).

*3: Press the engine switch and check that the power source mode turns off.

*4: Release the brake pedal, open the driver side door and check that the steering lock locks.

(h) Enter the following menus: Body Electrical / Starting Control / Data List.

(i) According to the display on the Techstream, read the Data List.

Starting Control









HINT
*: With the engine switch on (IG), the shift lever in P and the brake pedal depressed, press the engine switch and check that the engine starts.

(j) Enter the following menus: Body Electrical / Combination Meter / Data List.

(k) According to the display on the Techstream, read the Data List.

Combination Meter





2. ACTIVE TEST

HINT
Using the Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

(a) Connect the Techstream to the DLC3.

(b) Turn the engine switch on (IG).

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / Power Source Control / Active Test.

(e) According to the display on the Techstream, perform the Active Test.

Power Source Control





(f) Enter the following menus: Body Electrical / Smart key / Active Test.

(g) According to the display on the Techstream, perform the Active Test.

Smart Key





(h) Enter the following menus: Body Electrical / Starting Control / Active Test.

(i) According to the display on the Techstream, perform the Active Test.

Starting Control