Mute Signal Circuit Between Navigation Receiver Assembly and Stereo Component Tuner Assembly

NAVIGATION / MULTI INFO DISPLAY: NAVIGATION SYSTEM (w/o USB Audio System): Mute Signal Circuit between Navigation Receiver Assembly and Stereo Component Tuner Assembly
- Mute Signal Circuit between Navigation Receiver Assembly and Stereo Component Tuner Assembly

DESCRIPTION

The navigation receiver assembly controls the volume according to the MUTE signal from the stereo component tuner assembly.

The MUTE signal is sent to reduce noise and a popping sound generated when switching the mode etc. If there is an open in the circuit, noise can be heard from the speakers when changing the sound source. If there is a short in the circuit, even though the navigation receiver assembly is functioning normally, no sound or only an extremely faint sound can be heard.

WIRING DIAGRAM





INSPECTION PROCEDURE

PROCEDURE

1. CHECK NAVIGATION RECEIVER ASSEMBLY

(a) Measure the voltage according to the value(s) in the table below.





Standard Voltage:





Text in Illustration





NG -- CHECK HARNESS AND CONNECTOR (STEREO COMPONENT TUNER - TELEVISION DISPLAY)

OK -- REPLACE NAVIGATION RECEIVER ASSEMBLY Removal

2. CHECK HARNESS AND CONNECTOR (STEREO COMPONENT TUNER - TELEVISION DISPLAY)

(a) Disconnect the L20 stereo component tuner assembly connector.

(b) Disconnect the D59 navigation receiver assembly connector.

(c) Measure the resistance according to the value(s) in the table below.

Standard Resistance (Check for Open):





Standard Resistance (Check for Short):





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR

OK -- REPLACE STEREO COMPONENT TUNER ASSEMBLY Removal