Operation Check
SEAT: AUTO ACCESS SEAT SYSTEM: OPERATION CHECK
1. CHECK AUTO ACCESS SEAT OPERATION (OPERATION START)
(a) Fully open the power slide door RH, move the shift position to the P position, and unfasten the seat belt.
HINT
The auto access seat will only operate when the power slide door RH is fully open, the shift position is in the P position, and the seat belt is unfastened.
(b) Operate the No. 2 power seat switch assembly (egress switch), and confirm that the buzzer sounds when the auto access seat begins egress operation.
OK:
(c) Operate the No. 2 power seat switch assembly (ingress switch), and confirm that the buzzer sounds when the auto access seat begins ingress operation.
OK:
2. CHECK AUTO ACCESS SEAT OPERATION (INGRESS COMPLETE)
(a) Fully open the power slide door RH, move the shift position to the P position, and unfasten the seat belt.
HINT
The auto access seat will only operate when the power slide door RH is fully open, the shift position is in the P position, and the seat belt is unfastened.
(b) Operate the No. 2 power seat switch assembly (egress switch) to move the auto access seat to a position other than the origin point.
(c) Operate the No. 2 power seat switch assembly (ingress switch), and confirm that the buzzer sounds when the auto access seat returns to the origin point.
OK:
3. CHECK AUTO ACCESS SEAT OPERATION (OPERATING CONDITIONS NOT MET)
(a) Fully open the power slide door RH, move the shift position to the P position, and unfasten the seat belt.
HINT
The auto access seat will only operate when the power slide door RH is fully open, the shift position is in the P position, and the seat belt is unfastened.
(b) Operate the No. 2 power seat switch assembly (egress switch) to move the auto access seat to a position other than the origin point.
(c) Confirm that the buzzer sounds when the power slide door is moved to a position other than the fully open position.
OK:
(d) Confirm that the buzzer sounds when the seat belt is fastened.
OK:
(e) Confirm that the buzzer sounds while the ignition switch is ON and the shift position is in a position other than P.
OK:
4. CHECK AUTO ACCESS SEAT OPERATION (EXCESSIVE LOAD REVERSE OPERATION)
(a) Operate the power seat switch assembly (front-rear slide switch) or the No. 2 power seat switch assembly (front-rear slide switch) to activate the auto access seat.
(b) Confirm that applying excessive load during auto access seat operation causes the auto access seat to reverse operation while the buzzer sounds.
OK:
5. CHECK AUTO ACCESS SEAT OPERATION (ACCESS SEAT MODE)
(a) Fully open the power slide door RH, move the shift position to the P position, and unfasten the seat belt.
HINT
The auto access seat will only operate when the power slide door RH is fully open, the shift position is in the P position, and the seat belt is unfastened.
(b) Operate the No. 2 power seat switch assembly (egress switch) to move the auto access seat from the origin point to the lower end, and measure the time it takes.
Standard:
(c) Operate the No. 2 power seat switch assembly (ingress switch) to move the auto access seat from the lower end to the origin point, and measure the time it takes.
Standard:
6. CHECK AUTO ACCESS SEAT OPERATION (POWER SEAT MODE)
(a) Operate the power seat switch assembly (front-rear slide switch) and the power seat switch assembly (reclining switch) and confirm that the auto access seat moves smoothly.
OK: