Replacement

U760E AUTOMATIC TRANSMISSION / TRANSAXLE: DIFFERENTIAL OIL SEAL: REPLACEMENT

1. DRAIN AUTOMATIC TRANSAXLE FLUID

(a) Remove the 2 bolts, clip and front fender apron seal LH.

(b) Remove the refill plug and gasket from the automatic transaxle.

(d) Using a 6 mm hexagon socket wrench, remove the No. 1 transmission oil filler tube from the automatic transaxle.

Text in Illustration

(e) Drain automatic transaxle fluid from the automatic transaxle.

(f) Using a 6 mm hexagon socket wrench, install the No. 1 transmission oil filler tube into the automatic transaxle.

Text in Illustration

Torque : 0.8 Nm (8 kgf-cm, 7 in-lbf)

(g) Using a 6 mm hexagon socket wrench, temporarily install the gasket and the overflow plug into the automatic transaxle.

HINT
Reuse the old gasket. The overflow plug will be removed again to adjust the fluid level.

(h) Temporarily install the gasket and the refill plug into the automatic transaxle.

HINT
Reuse the old gasket. The refill plug will be removed again to adjust the fluid level.

2. REMOVE FRONT DRIVE SHAFT ASSEMBLY

Removal

3. REMOVE TRANSAXLE CASE OIL SEAL

(a) Using SST, tap out the transaxle case oil seal.

SST : 09308-00010

4. REMOVE FRONT TRANSAXLE CASE OIL SEAL

(a) Using SST, tap out the front transaxle case oil seal.

SST : 09308-00010

5. INSTALL TRANSAXLE CASE OIL SEAL

(a) Coat the lip of a new transaxle case oil seal with a small amount of MP grease.

(b) Using SST and a hammer, tap in the transaxle case oil seal.

SST : 09316-10010

SST : 09950-70010

09951-07100

Oil seal tap in depth:

-0.5 to 0.5 mm (-0.0197 to 0.0196 in.)

NOTICE:
Check that the oil seal is installed in the correct direction.

6. INSTALL FRONT TRANSAXLE CASE OIL SEAL

(a) Coat the lip of a new front transaxle case oil seal with a small amount of MP grease.

(b) Using SST and a hammer, tap in the front transaxle case oil seal.

SST : 09316-60011

09316-00011

Oil seal tap in depth:

-0.5 to 0.5 mm (-0.0197 to 0.0196 in.)

NOTICE:
Check that the oil seal is installed in the correct direction.

7. INSTALL FRONT DRIVE SHAFT ASSEMBLY

Installation