Installation

U760E AUTOMATIC TRANSMISSION / TRANSAXLE: SHIFT LEVER: INSTALLATION

1. CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

(a) Check that the park/neutral position switch and the shift lever are in N position.

(b) Rotate the transmission control cable nut counterclockwise approximately 270° and, while holding the nut in that position, press in the stopper until it makes 2 "click" sounds.

Text in Illustration

Text in Illustration

(d) Connect the cable outer of the transmission control cable onto the shift lever retainer, check that the position of the spring is the same as A shown in the illustration, and press in the stopper.

HINT
If the stopper cannot be pressed in, slightly rotate the nut clockwise and then press in the stopper.

(e) Connect the transmission control cable end to the shift lever.

Text in Illustration

NOTICE:
Check that the lock piece is pulled up.

2. INSTALL SHIFT LEVER ASSEMBLY

(a) Install the shift lever with the 4 nuts.

Torque : 12 Nm (122 kgf-cm, 9 ft-lbf)

(b) Connect the shift lock control ECU connector and transmission control switch wire connector.

(c) Press in and lock the lock piece to the adjuster case.

Text in Illustration

NOTICE:
* Check that the park/neutral position switch and the shift lever are in N position.
* Securely press in the lock piece until the lock engages.

3. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY Installation

4. INSTALL INSTRUMENT PANEL FINISH PANEL END RH Installation

5. INSTALL INSTRUMENT PANEL FINISH PANEL END LH Installation

6. INSTALL LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY Installation

7. INSTALL LOWER CENTER INSTRUMENT COVER (w/ Console Box) Installation

8. INSTALL LOWER CENTER INSTRUMENT COVER (w/o Console Box) Installation

9. INSTALL CONSOLE BOX ASSEMBLY (for Fixed Type)

Installation

10. INSTALL CONSOLE BOX ASSEMBLY (for Slide Type)

Installation

11. INSTALL AIR CONDITIONING CONTROL ASSEMBLY (for Automatic Air Conditioning System) Installation

12. INSTALL AIR CONDITIONING CONTROL ASSEMBLY (for Manual Air Conditioning System) Installation

13. INSTALL FLOOR SHIFT POSITION INDICATOR HOUSING SUB-ASSEMBLY Installation

14. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY

15. INSTALL GLOVE COMPARTMENT DOOR SUB-ASSEMBLY Installation

16. INSTALL NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH Installation

17. INSTALL KNEE AIRBAG ASSEMBLY Installation

18. INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL Installation

19. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP RH

20. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH

21. INSTALL COWL SIDE TRIM BOARD RH Installation

22. INSTALL COWL SIDE TRIM BOARD LH Installation

23. INSTALL FRONT DOOR SCUFF PLATE RH Installation

24. INSTALL FRONT DOOR SCUFF PLATE LH Installation

25. INSPECT SHIFT LEVER OPERATION

Initial Inspection and Diagnostic Overview