Disassembly

ENGINE HOOD / DOOR: HOOD: DISASSEMBLY

HINT
For bolts without torque specifications, check the standard bolt chart Standard Bolt - Specified Torque For Standard Bolts.

1. REMOVE RADIATOR GRILLE Removal

2. REMOVE NO. 2 HOOD LOCK RELEASE LEVER PROTECTOR Adjustments

3. REMOVE HOOD LOCK ASSEMBLY





(a) Remove the 3 bolts.

(b) Disconnect the hood lock control cable assembly, then remove the hood lock assembly.





4. REMOVE HOOD SUPPORT





(a) Remove the hood support.

(b) Remove the grommet.

(c) Using a clip remover, disengage the 2 claws and remove the hood stay holder.





5. REMOVE WASHER NOZZLE SUB-ASSEMBLY





(a) Disengage the 2 claws and remove the washer nozzle sub-assembly.

(b) Disconnect the washer hose.

6. REMOVE HOOD LOCK CONTROL CABLE PROTECTOR SUB-ASSEMBLY





(a) Remove the 2 nuts, then remove the hood lock control cable protector sub-assembly.

7. REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY





(a) Disengage the 2 claws.

(b) Disconnect the hood lock control cable assembly and remove the hood lock control lever sub-assembly.





8. REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY





(a) Tie a piece of string to the tip of the hood lock control cable assembly.

HINT
Use a piece of string which is longer than the hood lock control cable assembly.

(b) Remove the hood lock control cable assembly referring to the illustration.





NOTICE:
Leave the string inside the wire harness grommet for the installation of the hood lock control cable assembly.