Removal

A750E AUTOMATIC TRANSMISSION: TRANSMISSION WIRE: REMOVAL

CAUTION:
When working with FIPG material, you must observe the following guidelines.

* Using a razor blade and gasket scraper, remove all the old FIPG material from the gasket surfaces.
* Thoroughly clean all components to remove all loose material.
* Clean both sealing surfaces with a non-residue solvent.
* Apply FIPG in an approximately 1 mm (0.04 in.) wide bead along the sealing surface.
* Parts must be assembled within 10 minutes of application. Otherwise, the FIPG material must be removed and reapplied.
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. DRAIN AUTOMATIC TRANSMISSION FLUID

(a) Remove the drain plug, gasket and drain ATF.

(b) Install a new gasket and drain plug.

Torque : 28 Nm (285 kgf-cm, 21 ft-lbf)

3. REMOVE AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY Removal

4. REMOVE VALVE BODY OIL STRAINER ASSEMBLY Removal

5. SEPARATE TRANSMISSION WIRE





(a) Remove the bolt and clamp.

(b) Disconnect the ATF temperature sensor.

(c) Disconnect the 7 connectors from the solenoid valves.

6. REMOVE TRANSMISSION WIRE





(a) Disconnect the transmission wire connector.

(b) Remove the bolt and pull out the transmission wire.