Removal

A340E AUTOMATIC TRANSMISSION: AUTOMATIC TRANSMISSION ASSEMBLY: REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. REMOVE PROPELLER SHAFT ASSEMBLY (for Regular Cab)

3. REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY (for Except Regular Cab)

4. DRAIN AUTOMATIC TRANSMISSION FLUID

(a) Remove the drain plug, gasket and drain ATF.

(b) Install a new gasket and drain plug.

Torque : 20 Nm (204 kgf-cm, 15 ft-lbf)

5. REMOVE TRANSMISSION OIL LEVEL GAUGE SUB-ASSEMBLY

6. REMOVE TRANSMISSION OIL FILLER TUBE SUB-ASSEMBLY





(a) Remove the 2 bolts and oil filler tube.

7. REMOVE NO.1 OIL COOLER OUTLET TUBE





(a) Remove the 3 bolts and 3 clamps.

(b) Using a union nut wrench, disconnect the oil cooler outlet tube No. 1.





8. REMOVE NO.1 OIL COOLER INLET TUBE

(a) Using a union nut wrench, disconnect the oil cooler inlet tube No. 1.

9. REMOVE MANIFOLD STAY





(a) Remove the 3 bolts and manifold stay.

10. DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY





(a) CABLE TYPE:

(1) Remove the nut and disconnect the transmission control cable.

(2) Remove the clip and disconnect the transmission control cable.

11. SEPARATE FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY





(a) ROD TYPE:

(1) Remove the clip and separate the floor shift gear shifting rod from the automatic transmission.

12. SUPPORT AUTOMATIC TRANSMISSION ASSEMBLY





(a) Support the automatic transmission assembly with a transmission jack.

13. REMOVE FRONT SUSPENSION MEMBER BRACKET





(a) Remove the 8 bolts and 2 front suspension member brackets.

14. REMOVE NO.3 FRAME CROSSMEMBER SUB-ASSEMBLY





(a) Disconnect the heated oxygen sensor connector.

(b) Remove the 4 bolts from the frame crossmember sub-assembly No. 3.





(c) Remove the 4 nuts, 4 bolts and frame crossmember sub-assembly No. 3.

15. REMOVE STARTER ASSEMBLY Removal

16. DISCONNECT CONNECTOR





(a) Tilt down the transmission.

NOTICE:
Take care so that the cooling fan does not come in contact with the fan shroud.

(b) Disconnect the park/neutral position switch connector.

(c) Disconnect the transmission wire connector.

(d) Disconnect the 2 speed sensor connectors.

(e) Disconnect the temperature sensor connector.

17. DISCONNECT WIRE HARNESS

18. REMOVE AUTOMATIC TRANSMISSION ASSEMBLY





(a) Remove flywheel housing dust seal.

(b) Turn the crankshaft to gain access to each bolt.

(c) Hold the crankshaft pulley bolt with a wrench and remove the 6 bolts.

(d) Remove the 7 bolts.





(e) Separate and remove the automatic transmission.

19. REMOVE NO.1 TRANSMISSION CONTROL CABLE BRACKET





(a) Remove the 2 bolts and transmission control cable bracket No. 1.

20. REMOVE REAR NO.1 ENGINE MOUNTING INSULATOR





(a) Remove the 4 bolts and engine mounting insulator rear No. 1.

21. REMOVE TORQUE CONVERTER CLUTCH ASSEMBLY