Removal

1GR-FE LUBRICATION: OIL PUMP (for 4WD and Pre-Runner): REMOVAL

1. DISCHARGE FUEL SYSTEM PRESSURE

Service Precautions

2. REMOVE BATTERY

3. DRAIN ENGINE COOLANT Service and Repair

4. DRAIN ENGINE OIL Removal

5. REMOVE POWER STEERING LINK ASSEMBLY

Removal

6. REMOVE FRONT DIFFERENTIAL CARRIER ASSEMBLY (for 4WD)

Removal

7. REMOVE V-BANK COVER Removal

8. REMOVE RADIATOR SUPPORT TO FRAME SEAL LH Removal

9. REMOVE FAN SHROUD Removal

10. REMOVE AIR CLEANER ASSEMBLY Removal

11. REMOVE OIL LEVEL GAUGE GUIDE

12. REMOVE WATER INLET Removal

13. SEPARATE PUMP ASSEMBLY, VANE Removal

14. REMOVE GENERATOR ASSEMBLY Removal

15. SEPARATE COOLER COMPRESSOR ASSEMBLY Removal

16. REMOVE V-RIBBED BELT TENSIONER ASSEMBLY Removal

17. REMOVE NO.2 IDLER PULLEY SUB-ASSEMBLY Removal

18. REMOVE NO.1 IDLER PULLEY SUB-ASSEMBLY Removal

19. REMOVE CRANKSHAFT PULLEY Removal

20. REMOVE NO.2 OIL PAN SUB-ASSEMBLY Removal

21. REMOVE OIL STRAINER SUB-ASSEMBLY Removal

22. REMOVE OIL PAN SUB-ASSEMBLY Removal

23. REMOVE INTAKE AIR SURGE TANK Removal

24. REMOVE IGNITION COIL ASSEMBLY Removal

25. REMOVE CYLINDER HEAD COVER SUB-ASSEMBLY Removal

26. REMOVE CYLINDER HEAD COVER SUB-ASSEMBLY LH Removal

27. REMOVE CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY Removal

28. REMOVE VVT SENSOR Removal

29. REMOVE OIL FILTER BRACKET SUB-ASSEMBLY

(a) Remove the 3 bolts, 2 nuts, oil filter bracket and gasket.

30. REMOVE TIMING CHAIN OR BELT COVER SUB-ASSEMBLY





(a) Remove the 24 bolts and 2 nuts.

(b) Remove the timing chain cover by prying between the timing chain cover and cylinder head or cylinder block with a screwdriver.





NOTICE:
Be careful not to damage the contact surfaces of the timing chain cover, cylinder block and cylinder head.

(c) Remove the O-ring from the LH cylinder head.

31. REMOVE TIMING GEAR CASE OR TIMING CHAIN CASE OIL SEAL Replacement