Installation

PROPELLER SHAFT: FRONT PROPELLER SHAFT ASSEMBLY (for 4WD): INSTALLATION

1. INSPECT FRONT PROPELLER SHAFT ASSEMBLY

HINT
When replacing the spider bearing, make sure that the grease fitting assembly hole is facing in the direction shown in the illustration.





2. INSTALL FRONT PROPELLER SHAFT ASSEMBLY





(a) Align the matchmarks on the yoke and differential flange.

(b) Install the propeller shaft with the 4 bolts, 4 nuts and 4 washers.

Torque : 88 Nm (899 kgf-cm, 65 ft-lbf)

(c) Align the matchmarks on the yoke and transfer flange.





(d) Install the propeller shaft with the 4 nuts and 4 washers.

Torque : 88 Nm (899 kgf-cm, 65 ft-lbf)

3. REMOVE PROPELLER SHAFT HEAT INSULATOR BRACKET SUB-ASSEMBLY





(a) Install the propeller shaft heat insulator bracket with the 2 bolts.

Torque : 16 Nm (160 kgf-cm, 12 ft-lbf)

4. REMOVE EXHAUST FRONT PIPE ASSEMBLY NO. 2 (for 1GR-FE) Installation