Removal

1GR-FE STARTING: STARTER (for 4WD): REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. REMOVE NO.1 ENGINE UNDER COVER SUB-ASSEMBLY

(a) Remove the 4 bolts, then remove the engine under cover.

3. REMOVE NO.2 EXHAUST FRONT PIPE ASSEMBLY

Removal

4. REMOVE FRONT FENDER SEAL LH





(a) Remove the 5 clips, then remove the front fender splash shield rear LH.

5. REMOVE NO.2 STEERING INTERMEDIATE SHAFT

(a) Loosen bolt A and remove bolt B, then separate the steering intermediate shaft No. 2





6. REMOVE STARTER ASSEMBLY

(a) Disconnect the terminal 50 connector from the starter assembly.





(b) Remove the nut, then remove the wire harness from terminal 30.

(c) Remove the 2 bolts, then remove the starter assembly.