Operation CHARM: Car repair manuals for everyone.

B2780





ENGINE IMMOBILISER: ENGINE IMMOBILISER SYSTEM: B2780: Push Switch / Key Unlock Warning Switch Malfunction
B2780 - Push Switch / Key Unlock Warning Switch Malfunction

DESCRIPTION

This DTC will be output if the transponder key ECU does not detect that the unlock warning switch is ON even when the ignition switch is ON. Under normal conditions, the unlock warning switch is ON when the ignition switch is ON.





WIRING DIAGRAM





INSPECTION PROCEDURE

HINT
When the transponder key ECU is replaced, reregister the ECU - ECM communication ID Engine Immobiliser System.

PROCEDURE

1. CLEAR DTC

(a) Clear the DTC Engine Immobiliser System.

NEXT -- Continue to next step.

2. CHECK FOR DTC

(a) Check for DTC Engine Immobiliser System.

OK:

DTC B2780 is not output.

NG -- READ VALUE USING TECHSTREAM (UNLOCK WARNING SWITCH)

OK -- USE SIMULATION METHOD TO CHECK How To Proceed With Troubleshooting

3. READ VALUE USING TECHSTREAM (UNLOCK WARNING SWITCH)

(a) Use the Data List to check if the unlock warning switch is functioning properly.

Immobiliser





OK:

ON (key is in ignition key cylinder) appears on the screen.

NG -- INSPECT UNLOCK WARNING SWITCH

OK -- REPLACE TRANSPONDER KEY ECU Removal

4. INSPECT UNLOCK WARNING SWITCH





(a) Remove the unlock warning switch Removal.

(b) Measure the resistance according to the value(s) in the table below.

Standard resistance:





NG -- REPLACE UNLOCK WARNING SWITCH Removal
OK -- Continue to next step.

5. CHECK HARNESS AND CONNECTOR (UNLOCK WARNING SWITCH - BODY GROUND)





(a) Disconnect the J18 switch connector.

(b) Measure the resistance according to the value(s) in the table below.

Standard resistance:





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.

6. CHECK HARNESS AND CONNECTOR (UNLOCK WARNING SWITCH - TRANSPONDER KEY ECU)





(a) Disconnect the J18 switch connector.

(b) Disconnect the J26 ECU connector.

(c) Measure the resistance according to the value(s) in the table below.

Standard resistance:





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR

OK -- REPLACE TRANSPONDER KEY ECU Removal