Installation

ENGINE HOOD / DOOR: HOOD LOCK CONTROL CABLE ASSEMBLY: INSTALLATION

HINT
A bolt without a torque specification is shown in the standard bolt chart Standard Bolt - Specified Torque For Standard Bolts.

1. INSTALL HOOD LOCK CONTROL CABLE ASSEMBLY

(a) Pass the cable into the engine room.

(b) Pass the cable rear side through the grommet until the cable stopper is attached to the grommet.

(c) Pass the cable front side through the upper radiator support.

(d) Attach the cable to the clamps as shown in the illustration.





2. INSTALL HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

(a) Connect the hood lock control cable to the hood lock lever.





(b) Attach the 2 claws to install the hood lock lever

3. INSTALL HOOD LOCK ASSEMBLY

(a) Apply MP grease to the sliding areas of the lock.





(b) Connect the hood lock control cable.





(c) Install the hood lock.

(d) Install the 2 bolts and nut.

Torque : 8.0 Nm (82 kgf-cm, 71 in-lbf)

(e) Install a new cap.

(f) w/ Theft Deterrent System:

Connect the connector.

4. INSTALL HOOD LOCK CONTROL CABLE COVER

(a) Attach the clamp to install the cable cover.





(b) Install the screw and nut.