Installation

1GR-FE LUBRICATION: OIL PRESSURE SWITCH: INSTALLATION

1. INSTALL ENGINE OIL PRESSURE SWITCH ASSEMBLY

(a) Apply adhesive to 2 or 3 threads of the oil pressure switch.

Adhesive:

Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent

NOTICE:
Do not apply adhesive to the oil inlet port of the oil pressure switch.

(b) Using a 24 mm deep socket wrench, install the oil pressure switch.

Torque : 15 Nm (153 kgf-cm, 11 ft-lbf)

NOTICE:
Do not start the engine within 1 hour of installation.

(c) Connect the oil pressure switch connector.

2. INSPECT FOR ENGINE OIL LEAK Replacement

3. INSTALL NO. 1 ENGINE UNDER COVER Replacement