Removal

1GR-FE CHARGING: GENERATOR: REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

2. REMOVE FAN AND GENERATOR V BELT Removal

3. REMOVE NO. 2 IDLER PULLEY SUB-ASSEMBLY

(a) for Integrated Type:

Remove the bolt and No. 2 idler pulley.





(b) for Separate Type:

Remove the bolt, No. 2 idler pulley cover plate, No. 2 idler pulley and idler pulley cover plate.

4. REMOVE FRONT FENDER APRON SEAL REAR LH Removal

5. REMOVE NO. 2 EXHAUST MANIFOLD HEAT INSULATOR Removal

6. REMOVE GENERATOR ASSEMBLY

(a) Remove the bolt and disconnect the wire harness bracket.





(b) Open the terminal cap.





(c) Remove the nut and disconnect the wire harness from terminal B.

(d) Disconnect the generator connector from the generator assembly.

(e) Disconnect the wire harness clamp.





(f) Remove the bolt and disconnect the generator bracket.

(g) Remove the 2 bolts and generator assembly.





(h) Remove the bolt and generator bracket.