Removal

1UR-FE INTAKE: INTAKE MANIFOLD: REMOVAL

1. DISCHARGE FUEL SYSTEM PRESSURE Removal

2. REMOVE EGR VALVE ASSEMBLY

(a) Remove the EGR valve Removal.

3. REMOVE FRONT WIPER MOTOR AND LINK ASSEMBLY

(a) Remove the front wiper motor and link Removal.

4. REMOVE COWL TOP OUTER PANEL SUB-ASSEMBLY

(a) Disconnect the washer hose and 2 wire harness clamps.

(b) Remove the 7 bolts and outer panel.





5. REMOVE VENTILATION HOSE ASSEMBLY

(a) Disconnect the ventilation hose from the ventilation pipe of the cylinder head cover LH and RH.





(b) Remove the bolt and ventilation hose.

6. REMOVE AIR TUBE SUB-ASSEMBLY LH Removal

7. REMOVE INTAKE MANIFOLD

(a) Disconnect the No. 4 water by-pass hose.





(b) Disconnect the throttle body connector.

(c) Disconnect the No. 1 ventilation hose.

(d) Disconnect the purge VSV connector.





(e) Disconnect the purge line hose from the purge VSV.

(f) Disconnect the vacuum switching valve connector (for ACIS).

(g) Disconnect the vacuum hose.





(h) Remove the bolt and disconnect the wire harness from the wire harness bracket.





(i) Detach the 3 wire harness clamps from the 3 wire harness brackets.

(j) Detach the 4 clamps from the fuel tube.





(k) Disconnect the fuel tube from the fuel delivery pipe RH Service Precautions.





(l) Disconnect the fuel tube from the fuel delivery pipe LH Service Precautions.





(m) Remove the 2 nuts, 8 bolts, intake manifold and 2 gaskets.





8. REMOVE FUEL TUBE SUB-ASSEMBLY

(a) Remove the bolt and fuel tube from the intake manifold.





9. REMOVE V-BANK COVER BRACKET

(a) Remove the 2 bolts and bracket.





10. REMOVE V-BANK COVER PIN

(a) Remove the pin from the intake manifold.





11. REMOVE STUD BOLT

(a) Using an E5 "TORX" socket wrench, remove the 2 stud bolts.





12. REMOVE VACUUM SWITCHING VALVE ASSEMBLY (for ACIS)

(a) Disconnect the 2 vacuum hoses from the vacuum switching valve.





(b) Remove the bolt and vacuum switching valve.

13. REMOVE PURGE VSV

(a) Disconnect the purge line hose from the intake manifold.





(b) Remove the bolt and purge VSV.

14. REMOVE UNION TO CONNECTOR TUBE HOSE ASSEMBLY

(a) Remove the 2 bolts and detach the hose clamp.





(b) Remove the union to connector tube hose from the intake manifold.

(c) Remove the 2 bolts and 2 wire harness brackets.

15. REMOVE MANIFOLD ABSOLUTE PRESSURE SENSOR Removal

16. REMOVE THROTTLE BODY ASSEMBLY

(a) Remove the 4 bolts, throttle body and gasket.