Removal

1UR-FE EMISSION CONTROL: AIR PUMP: REMOVAL

1. DISCONNECT FRONT FENDER LINER RH

(a) Remove the 8 clips, disconnect the fender liner.





2. DISCONNECT FRONT FENDER APRON SEAL RH

(a) Using a clip remover, remove the 2 clips and fold back the fender apron seal.





3. REMOVE NO. 2 AIR INJECTION SYSTEM HOSE

(a) Engine Room Side:





(1) Disconnect the 2 clamps.

(2) Disconnect the No. 2 air injection system hose.

(3) Using a clip remover, remove the clamp from the body panel.

(b) Front Fender RH Inside:

(1) Disconnect the clamp.

(2) Disconnect the No. 2 air injection system hose from the air pump.

4. REMOVE NO. 3 AIR INJECTION SYSTEM HOSE

(a) Engine Room Side:





(1) Disconnect the clamp and No. 3 air injection system hose.

(2) Using a clip remover, remove the clamp from the body panel.

(b) Front Fender RH Inside:

(1) Disconnect the No. 3 air injection system hose from the air pump.

(2) Using a clip remover, remove the clamp from the body panel.

5. REMOVE AIR PUMP ASSEMBLY WITH BRACKET

(a) Disconnect the 2 air pump connectors and detach the 3 wire harness claws.





(b) Remove the 2 bolts, 2 nuts and air pump.





6. REMOVE AIR PUMP INLET

(a) Remove the 2 bolts, slide the 2 clips off of the No. 1 air injection system hoses, disconnect the hoses and remove the air pump inlet.





7. DISCONNECT NO. 1 AIR INJECTION SYSTEM HOSE

(a) Disconnect the 2 No. 1 air injection system hoses.

8. REMOVE AIR PUMP ASSEMBLY

(a) Using a clip remover, detach the 2 clamps and remove the air pump from the bracket.





(b) Disconnect the 6 air pump insulators.