Removal

1UR-FE FUEL: FUEL PUMP: REMOVAL

1. REMOVE FUEL TANK ASSEMBLY

(a) Remove the fuel tank Removal.

2. REMOVE FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY

(a) Remove the 2 tube joint clips and pull out the 2 fuel tank tubes.





NOTICE:
* Remove any dirt and foreign matter on the fuel tube joint before performing this work.
* Do not allow any scratches or foreign matter on the parts when disconnecting them, as the fuel tube joint contains the O-rings that seal the plug.
* Perform this work by hand. Do not use any tools.
* Do not forcibly bend, twist or turn the nylon tube.
* Protect the disconnected part by covering it with a plastic bag and tape after disconnecting the fuel tubes.

(b) Using SST, loosen the retainer.





SST : 09808-14020

HINT
Fit the tips of SST onto the ribs of the retainer.

NOTICE:
* When the retainer is loosened, be careful as the pump and gauge tube will spring upward from the force of the spring.
* Clean the pump and gauge tube before this operation.

(c) Remove the retainer.

(d) Remove the fuel suction with pump and gauge tube assembly from the fuel tank.

NOTICE:
Be careful not to bend the arm of the fuel sender gauge.

(e) Remove the gasket from the fuel tank.