Removal

A760E AUTOMATIC TRANSMISSION: AUTOMATIC TRANSMISSION ASSEMBLY: REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. REMOVE NO. 1 ENGINE UNDER COVER Replacement

3. DRAIN AUTOMATIC TRANSMISSION FLUID Removal

4. DRAIN ENGINE COOLANT Service and Repair

5. REMOVE PROPELLER SHAFT ASSEMBLY

Removal

6. REMOVE FRONT EXHAUST PIPE ASSEMBLY

(a) for Regular Cab Standard Deck:

Removal.

(b) except Regular Cab Standard Deck:

Removal.

7. DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY





(a) Remove the nut and clip, and disconnect the transmission control cable.

8. REMOVE STARTER ASSEMBLY

Removal

9. REMOVE DRIVE PLATE AND TORQUE CONVERTER CLUTCH SETTING BOLT





(a) Remove the flywheel housing side cover.

(b) Turn the crankshaft to gain access to the 6 bolts and remove each bolt while holding the crankshaft pulley bolt with a wrench.





10. SUPPORT AUTOMATIC TRANSMISSION ASSEMBLY





(a) Support the transmission with a transmission jack. Lift the transmission slightly from the crossmember.

11. REMOVE NO. 3 FRAME CROSSMEMBER SUB-ASSEMBLY





(a) Remove the 4 bolts of the rear engine mounting insulator.

(b) Remove the 4 nuts, 4 washers, 4 bolts and crossmember.





12. REMOVE REAR NO. 1 ENGINE MOUNTING INSULATOR





(a) Remove the 4 bolts and rear engine mounting insulator from the transmission.

13. DISCONNECT WIRE HARNESS AND CONNECTOR





(a) Remove the bolt and disconnect the ground cable.

(b) Tilt the transmission downward.





NOTICE:
Make sure the cooling fan does not contact the fan shroud.

(c) Disconnect the park/neutral position switch connector, transmission wire connector and 2 speed sensor connectors.





HINT
Detach the claw, press down the lever, and then disconnect the transmission wire connector.

(d) Detach the 4 connector clamps and 5 harness clamps.

(e) Remove the bolt, disconnect the harness clamp and wire harness.

14. DISCONNECT WATER BY-PASS PIPE Removal

15. REMOVE TRANSMISSION OIL COOLER ASSEMBLY (w/o Trailer Towing System) Removal

16. REMOVE TRANSMISSION OIL COOLER ASSEMBLY (w/ Trailer Towing System) Removal

17. REMOVE AUTOMATIC TRANSMISSION ASSEMBLY





(a) Remove the 10 bolts and transmission.

NOTICE:
Do not use excess force when prying the transmission assembly.

18. REMOVE HARNESS CLAMP BRACKET





(a) Remove the 5 bolts and 5 brackets.

19. REMOVE TRANSMISSION CONTROL CABLE BRACKET





(a) Remove the 2 bolts and bracket.

20. REMOVE TORQUE CONVERTER CLUTCH ASSEMBLY

21. INSPECT TORQUE CONVERTER CLUTCH ASSEMBLY

Testing and Inspection