Removal

3UR-FE EXHAUST: EXHAUST PIPE (except Regular Cab Standard Deck): REMOVAL

CAUTION:
* Wear protective gloves when removing the exhaust pipe.
* The exhaust pipe is extremely hot immediately after the engine has stopped.
* Confirm that the exhaust pipe has cooled down before removing it.
1. REMOVE TAILPIPE ASSEMBLY

(a) Remove the bolt, clamp and gasket.

(b) Disconnect the tailpipe from the exhaust pipe support.

2. REMOVE CENTER EXHAUST PIPE ASSEMBLY

(a) Remove the 4 bolts.

(b) Disconnect the center exhaust pipe from the 3 exhaust pipe supports.

(c) Remove the center exhaust pipe from the front exhaust pipe and front No. 2 exhaust pipe.

(d) Remove the 2 gaskets from the front exhaust pipe.

3. REMOVE PROPELLER SHAFT HEAT INSULATOR (for 4WD) Removal

4. REMOVE FRONT PROPELLER SHAFT ASSEMBLY (for 4WD) Removal

5. REMOVE FRONT NO. 2 EXHAUST PIPE ASSEMBLY

(a) Disconnect the air fuel ratio sensor connector.

(b) Disconnect the heated oxygen sensor connector.

(c) Remove the 3 nuts.

(d) Disconnect the front No. 2 exhaust pipe from the exhaust pipe support to remove it.

(e) Remove the gasket.

6. REMOVE FRONT EXHAUST PIPE ASSEMBLY

(a) Disconnect the air fuel ratio sensor connector.

(b) Disconnect the heated oxygen sensor connector and 2 clamps.

(c) Remove the 3 nuts and the front exhaust pipe from the exhaust manifold RH.

(d) Remove the gasket.

7. REMOVE AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1) Removal

8. REMOVE AIR FUEL RATIO SENSOR (for Bank 2 Sensor 1) Removal

9. REMOVE HEATED OXYGEN SENSOR (for Bank 1 Sensor 2) Removal

10. REMOVE HEATED OXYGEN SENSOR (for Bank 2 Sensor 2) Removal