Removal

DOOR / HATCH: BACK DOOR SUPPORT: REMOVAL

1. REMOVE BACK DOOR DAMPER STAY SUB-ASSEMBLY LH

NOTICE:
* Avoid touching the piston rod as much as possible to prevent foreign matter from attaching to it. Be sure to hold the cylinder while servicing the vehicle.
* Do not wear cotton gloves or other similar materials when handling the piston rod. Fibers may attach to the rod and result in gas leaks.
* In order to prevent the piston rod from deforming, do not apply any horizontal load to the door damper stay.

(a) Using a screwdriver, remove the stop ring along the groove.

HINT
Tape the screwdriver tip before use.





Text in Illustration





(b) Release the ball joint and remove the back door damper stay sub-assembly.

NOTICE:
Remove the back door damper stay sub-assembly while supporting the back door by hand.

2. REMOVE BACK DOOR STAY BOLT

(a) Remove the back door stay bolt.

NOTICE:
If the hood support is detached from the ball joint, it becomes non-reusable. Therefore, do not detach the hood support from the ball joint unless replacing it.





3. REMOVE BACK DOOR UPPER DAMPER STAY BRACKET LH

(a) Remove the 2 bolts and back door upper damper stay bracket.