Installation

SUPPLEMENTAL RESTRAINT SYSTEMS: SPIRAL CABLE: INSTALLATION

1. INSTALL SPIRAL CABLE SUB-ASSEMBLY

(a) Attach the 3 claws to install the spiral cable.

CAUTION:
When replacing the spiral cable with a new one, remove the lock pin before installing the steering wheel assembly.

(b) Connect the connectors to the spiral cable.

NOTICE:
When handling the airbag connector, take care not to damage the airbag wire harness.

2. INSTALL UPPER STEERING COLUMN COVER Installation

3. INSTALL LOWER STEERING COLUMN COVER Installation

4. ADJUST SPIRAL CABLE SUB-ASSEMBLY

(a) Turn the ignition switch off.

(b) Disconnect the cable from the negative (-) battery terminal.

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

(c) Rotate the spiral cable counterclockwise slowly by hand until it feels firm.





CAUTION:
Do not turn the spiral cable by the airbag wire harness.

(d) Rotate the spiral cable clockwise approximately 2.5 turns to align the marks.





Text in Illustration





CAUTION:
Do not turn the spiral cable by the airbag wire harness.

HINT
The spiral cable can be rotated approximately 2.5 turns to both the left and right from the center position.

5. INSTALL STEERING WHEEL ASSEMBLY

(a) Install the steering wheel assembly Installation.