Removal

SUSPENSION CONTROL: STABILIZER CONTROL VALVE (w/ KDSS): REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

2. REMOVE FRONT WHEEL

3. REMOVE REAR WHEEL

4. REMOVE SIDE STEP ASSEMBLY LH Removal

5. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY Removal

6. REMOVE STABILIZER CONTROL VALVE PROTECTOR

(a) Remove the 2 bolts and stabilizer control valve protector.





7. DRAIN SUSPENSION FLUID

(a) Loosen the bleeder plug on the stabilizer control with accumulator housing assembly and drain suspension fluid.





HINT
* Drain suspension fluid when performing operations related to the hydraulic circuits.
* Draining suspension fluid decreases suspension fluid pressure.

(b) Tighten the bleeder plug.

Torque : 8.3 Nm (85 kgf-cm, 73 in-lbf)

8. REMOVE FRONT STABILIZER TUBE PROTECTOR

(a) Remove the 2 bolts and front stabilizer tube protector.





9. REMOVE FRONT STABILIZER CONTROL TUBE INSULATOR

(a) Remove the 2 bolts and front stabilizer control tube insulator.





10. REMOVE FRONT STABILIZER CONTROL TUBE





(a) Using a union nut wrench, disconnect the 4 flare nuts.

(b) Remove the 2 bolts and front stabilizer control tubes.

11. REMOVE REAR STABILIZER CONTROL TUBE





(a) Using a union nut wrench, disconnect the 2 flare nuts.

(b) Remove the 2 union bolts of the rear stabilizer control cylinder and the 2 pressure port gaskets.

(c) Remove the 4 bolts and rear stabilizer control tubes.

12. REMOVE STABILIZER CONTROL WITH ACCUMULATOR HOUSING ASSEMBLY

(a) Disconnect the connector, and then detach the clamp from the sensor bracket.





(b) Remove the 3 bolts and stabilizer control with accumulator housing.

NOTICE:
Do not disassemble the stabilizer control with accumulator housing assembly or expose it to an open flame as the accumulator of the stabilizer control with accumulator housing assembly contains gas.