Removal

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: STEERING ANGLE SENSOR: REMOVAL

1. PLACE FRONT WHEELS FACING STRAIGHT AHEAD

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

3. REMOVE STEERING WHEEL ASSEMBLY

(a) Remove the steering wheel assembly Removal.

4. REMOVE LOWER STEERING COLUMN COVER Removal

5. REMOVE UPPER STEERING COLUMN COVER Removal

6. REMOVE SPIRAL CABLE WITH STEERING ANGLE SENSOR

(a) Remove the spiral cable with steering angle sensor Removal.

NOTICE:
* Do not replace the spiral cable with the battery connected and the ignition switch ON.
* Do not rotate the spiral cable with the battery connected and the ignition switch ON.
* Make sure that the steering wheel is installed and aligned straight when inspecting the steering angle sensor.
* Do not remove the steering angle sensor from the spiral cable.