Removal

WINDOW / GLASS: BACK DOOR POWER WINDOW MOTOR: REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

2. REMOVE BACK DOOR TRIM PANEL ASSEMBLY Disassembly

3. REMOVE REAR NO. 2 SPEAKER ASSEMBLY Removal

4. REMOVE MULTIPLEX NETWORK DOOR ECU Disassembly

5. REMOVE NO. 2 BACK DOOR SERVICE HOLE COVER Disassembly

6. REMOVE BACK DOOR SERVICE HOLE COVER LH Disassembly

7. REMOVE BACK DOOR SERVICE HOLE COVER RH Disassembly

8. REMOVE BACK DOOR OUTSIDE MOULDING LH

9. REMOVE BACK DOOR OUTSIDE MOULDING RH

HINT
Use the same procedure described for the LH side.

10. REMOVE REAR NO. 1 SPOILER COVER Removal

11. REMOVE REAR SPOILER SUB-ASSEMBLY Removal

12. REMOVE REAR WIPER ARM Removal

13. REMOVE REAR WIPER MOTOR ASSEMBLY Removal

14. REMOVE NO. 1 BACK WINDOW WIPER MOTOR BRACKET Disassembly

15. REMOVE BACK DOOR GLASS RUN Disassembly

16. REMOVE BACK DOOR GLASS Disassembly

17. REMOVE OUTER BACK DOOR GLASS WEATHERSTRIP ASSEMBLY

18. REMOVE BACK DOOR POWER WINDOW REGULATOR SUB-ASSEMBLY Disassembly

19. REMOVE BACK DOOR POWER WINDOW REGULATOR MOTOR ASSEMBLY





(a) Using a T25 "TORX" socket wrench, remove the 3 screws and power window regulator motor.

NOTICE:
Be careful when removing the screws as the motor may fall and become damaged.