Security Lamp/Indicator: Testing and Inspection

THEFT DETERRENT: SECURITY INDICATOR LIGHT ASSEMBLY: INSPECTION

1. INSPECT SECURITY INDICATOR LIGHT

(a) Disconnect the D40 ECU connector, with the E19 indicator connector connected. (w/ Smart Key System)





(b) Disconnect the D10 ECU connector, with the E19 indicator connector connected. (w/o Smart Key System)

(c) Apply battery voltage from the wire harness back side between the terminals of the indicator, and check the lighting condition of the security indicator.

Standard:





NOTICE:
* If the positive (+) lead and the negative (-) lead are incorrectly connected, the security indicator will not come on.
* Voltage of more than 12 V will damage the security indicator.
* If the voltage is too low, the security indicator will not come on.

If the result is not as specified, replace the passenger belt and airbag indicator.