Programming and Relearning

SLIDING ROOF: SLIDING ROOF SYSTEM: INITIALIZATION

1. INITIALIZE SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY

NOTICE:
Be sure to initialize the sliding roof drive gear (pulse sensor) after adjusting the sliding roof glass position or removing and installing components. Without initialization, there may be a malfunction in the sliding roof auto operation, or key-off operation.

If any of the following conditions occurs during initialization procedure, initialization will fail.

* The ignition switch is turned off.
* Communication is cut off.
* Another switch is turned on during initialization.
* Vehicle speed is 5 km/h (3 mph) or more.
* The vehicle experiences a strong vibration during initialization, such as the slamming of a door.

(a) Initialization

HINT
According to the following chart, proceed to the appropriate initialization procedure.





(1) [A] The sliding roof AUTO function does not operate.

1 Turn the ignition switch on (IG). *1

2 Fully close the sliding roof.

3 Press and hold the sliding roof switch (TILT UP side) until the following movement finishes: Tilt up -> stationary state for at least 1 second -> tilt down -> slide open -> slide close.

NOTICE:
Press and hold the sliding roof switch (TILT UP side) until step *2 is complete. If the switch is released before step *2 is complete, restart from step *1.

4 Confirm that the roof glass is stopped at the fully closed position and initialization is completed. *2

(2) [B] Although the sliding roof AUTO function operates, the roof glass stops moving or starts moving in the opposite direction while tilting downward.

1 Turn the ignition switch on (IG). *1

2 Press and hold the sliding roof switch (TILT UP side) until the sliding roof stops.

3 After the sliding roof stops, release the switch.

4 Press and hold the sliding roof switch (TILT UP side) for more than 10 seconds until the following movement finishes: Tilt up -> stationary state for at least 1 second -> tilt down -> slide open -> slide close.

NOTICE:
Press and hold the sliding roof switch (TILT UP side) until step *2 is complete. If the switch is released before step *2 is complete, restart from step *1.

5 Confirm that the roof glass is stopped at the fully closed position and initialization is complete. *2

6 Confirm that the sliding roof can be normally operated with the AUTO function.

(3) [C] Although the sliding roof AUTO function operates, the roof glass stops moving or starts moving in the opposite direction while sliding closed.

1 Turn the ignition switch on (IG). *1

2 Press and hold sliding roof switch (TILT UP side) until the following movement finishes: Slide close -> roof glass stops moving or starts moving in the opposite direction -> stationary for at least 10 seconds -> slide close.

NOTICE:
Press and hold sliding roof switch (TILT UP side) until step *2 is complete. If the switch is released before step *2 is complete, restart from step *1.

3 After the sliding roof has stopped at the fully closed position, release the switch. *2

4 Follow the initialization procedure described in [A] (The sliding roof AUTO function does not function.)