Installation

PARKING BRAKE: PARKING BRAKE PEDAL: INSTALLATION

1. INSTALL PARKING BRAKE CONTROL PEDAL ASSEMBLY

(a) Install the parking brake control pedal assembly with the 3 nuts.

Torque : 21 Nm (214 kgf-cm, 15 ft-lbf)

(b) Connect the parking brake switch connector.

(d) Install the No. 1 parking brake cable assembly with the 2 bolts and 2 nuts.

Bolt - Torque : 8.5 Nm (87 kgf-cm, 75 in-lbf)

Nut - Torque : 6.0 Nm (61 kgf-cm, 53 in-lbf)

(e) Install the clamp.

(f) Temporarily install the lock nut.

HINT
After adjusting parking brake pedal travel, tighten the lock nut.

2. INSTALL PARKING BRAKE EQUALIZER

(a) Install the parking brake equalizer to the No. 1 parking brake cable assembly as shown in the illustration.

(b) Slide the rubber boot back as shown in the illustration.

3. CONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY

(a) Connect the No. 3 parking brake cable assembly to the parking brake equalizer.

4. CONNECT NO. 2 PARKING BRAKE CABLE ASSEMBLY

HINT
Perform the same procedure as for the No. 3 parking brake cable assembly.

5. INSTALL REAR ENGINE SERVICE COVER ASSEMBLY

(a) Install the rear engine service cover assembly with the 2 bolts.

6. INSTALL CENTER FRONT FLOOR COVER

(a) Engage the 4 clips to install the center front floor cover.

(b) Install the 4 bolts, 2 screws, and the nut.

7. INSTALL FRONT FLOOR FOOTREST

(a) Engage the 2 clips to install the front floor footrest.

8. INSTALL REAR NO. 1 AIR DUCT

(a) Install the rear No. 1 air duct.

(b) Engage the wire harness clamp.

9. INSTALL REAR NO. 2 AIR DUCT

(a) Install the rear No. 2 air duct with the clip.

(b) Install the floor carpet.

10. INSTALL FRONT NO. 1 CONSOLE BOX INSERT Installation

11. INSTALL CONSOLE BOX ASSEMBLY (w/ Rear Air Conditioning System) Installation

12. INSTALL CONSOLE BOX ASSEMBLY (w/o Rear Air Conditioning System) Installation

13. INSTALL LOWER REAR CONSOLE BOX Installation

14. INSTALL NO. 2 CONSOLE BOX DUCT (w/o Rear Air Conditioning System) Installation

15. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY Installation

16. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY (w/o Smart Key System) Installation

17. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY (w/ Smart Key System) Installation

18. INSTALL INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY Installation

19. INSTALL LOWER CENTER PILLAR GARNISH LH Installation

20. INSTALL REAR DOOR SCUFF PLATE LH Installation

21. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY (for Manual Air Conditioning System) Installation

22. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY (for Automatic Air Conditioning System) Installation

23. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH Installation

24. INSTALL FRONT DOOR SCUFF PLATE LH Installation

25. INSTALL FRONT SEAT ASSEMBLY LH (for Manual Seat) Installation

26. INSPECT FRONT SEAT SLIDE ADJUSTER LOCK (for Manual Seat) Installation

27. INSTALL REAR SEAT TRACK COVER LH (for Manual Seat) Installation

28. INSTALL FRONT INNER SEAT TRACK COVER LH (for Manual Seat) Installation

29. INSTALL FRONT OUTER SEAT TRACK COVER LH (for Manual Seat) Installation

30. INSTALL FRONT SEAT HEADREST ASSEMBLY LH (for Manual Seat) Installation

31. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (for Manual Seat)

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

32. INSTALL FRONT SEAT ASSEMBLY LH (for Power Seat) Installation

33. INSTALL REAR INNER SEAT TRACK COVER LH (for Power Seat) Installation

34. INSTALL REAR OUTER SEAT TRACK COVER LH (for Power Seat) Installation

35. INSTALL FRONT INNER SEAT TRACK COVER LH (for Power Seat) Installation

36. INSTALL FRONT OUTER SEAT TRACK COVER LH (for Power Seat) Installation

37. INSTALL FRONT SEAT HEADREST ASSEMBLY LH (for Power Seat) Installation

38. INSPECT FRONT SEAT ASSEMBLY LH (for Power Seat) Installation

39. ADJUST PARKING BRAKE SHOE CLEARANCE AND PARKING BRAKE PEDAL TRAVEL Adjustments

40. INSPECT BRAKE WARNING LIGHT Adjustments