Installation

SUPPLEMENTAL RESTRAINT SYSTEM: CURTAIN SHIELD AIRBAG ASSEMBLY: INSTALLATION

1. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY

(a) Check that the ignition switch is off.

(b) Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:
Wait for at least 90 seconds after disconnecting the cable to prevent airbag deployment.

(c) Temporarily install the curtain shield airbag assembly to the body panel with the 11 hooks.

NOTICE:
Do not twist the curtain shield airbag assembly when installing it.

(d) Install 11 new bolts.

Torque : 12.5 Nm (127 kgf-cm, 9 ft-lbf)

HINT
Tighten the bolts in the order shown in the illustration.





(e) Connect the curtain shield airbag connector.

NOTICE:
When handling the airbag connector, take care not to damage the airbag wire harness.





2. INSTALL ROOF HEADLINING ASSEMBLY

Installation

3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

4. INSPECT SRS WARNING LIGHT

(a) Inspect the SRS warning light Diagnosis System.