Installation
SUPPLEMENTAL RESTRAINT SYSTEM: FRONT SEAT SIDE AIRBAG ASSEMBLY: INSTALLATION
1. INSTALL FRONT SEAT SIDE AIRBAG ASSEMBLY
CAUTION:
* The nuts must not be reused.
* Make sure that the seat frame assembly is not deformed. If it is, replace it with a new one.
(a) Install the front seat side airbag assembly with 2 new nuts.
Torque : 5.5 Nm (56 kgf-cm, 49 in-lbf)
(b) Engage the 2 clamps to connect the wire harness.
2. INSTALL FRONT SEATBACK COVER WITH PAD
(a) Temporarily install the front seatback cover with pad to the front seat frame assembly with adjuster.
(b) Engage the 4 claws and install the 2 front seat headrest supports.
(c) Engage the hook and install the separate type front seatback cover bracket with the nut.
Torque : 5.6 Nm (57 kgf-cm, 50 in-lbf)
NOTICE:
* For vehicles with side airbags, the side airbags may not activate normally unless the front seatback cover is securely installed.
* Check that the strap is not twisted after installing the bracket.
* Install the bracket securely.
(d) Engage the 2 hooks.
(e) Using hog ring pliers, install 2 new hog rings.
NOTICE:
* Be careful not to damage the cover.
* When installing the hog rings, take care to minimize wrinkles as much as possible.
(f) Close the 2 fasteners.
(g) Using hog ring pliers, install the front seatback cover with pad with 3 new hog rings.
NOTICE:
* Be careful not to damage the cover.
* When installing the hog rings, take care to minimize wrinkles as much as possible.
(h) w/ Seat Heater:
(1) Connect the connector and engage the 2 clamps.
3. INSTALL AIRBAG WIRE HARNESS (for Manual Seat)
(a) Engage the claw and 4 clamps to install the airbag wire harness.
(b) Engage the 2 hooks.
4. INSTALL AIRBAG WIRE HARNESS (for Power Seat)
(a) Engage the claw and 4 clamps to install the airbag wire harness.
(b) Engage the 2 hooks.
5. INSTALL FRONT SEAT ASSEMBLY
for Manual Seat: Installation
for Power Seat: Installation
6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.
7. INSPECT SLIDE ADJUSTER LOCK (for Manual Seat)
8. INSPECT SRS WARNING LIGHT
HINT
Check the SRS warning light Diagnosis System.