Removal

MF2A TRANSFER: TRANSFER ASSEMBLY: REMOVAL

1. DISCHARGE FUEL SYSTEM PRESSURE Removal

2. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM Service and Repair

3. REMOVE COOL AIR INTAKE DUCT SEAL Removal

4. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Removal.

5. REMOVE BATTERY Removal

6. PLACE FRONT WHEELS FACING STRAIGHT AHEAD

7. REMOVE FRONT WHEELS

8. REMOVE ENGINE UNDER COVER ASSEMBLY Removal

9. REMOVE NO. 1 ENGINE UNDER COVER Removal

10. REMOVE NO. 2 ENGINE UNDER COVER Removal

11. REMOVE FLOOR UNDER COVER LH

12. REMOVE FRONT FENDER MOULDING SUB-ASSEMBLY LH Removal

13. REMOVE FRONT FENDER MOULDING SUB-ASSEMBLY RH Removal

14. REMOVE FRONT FENDER LINER LH Removal

15. REMOVE FRONT FENDER LINER RH Removal

16. REMOVE FRONT FENDER APRON SEAL LH Removal

17. REMOVE FRONT FENDER APRON SEAL RH Removal

18. DRAIN ENGINE OIL Replacement

19. DRAIN ENGINE COOLANT Service and Repair

20. DRAIN AUTOMATIC TRANSAXLE FLUID Removal

21. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH Removal

22. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH Removal

23. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY Removal

24. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY Removal

25. REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY Removal

26. REMOVE V-BANK COVER SUB-ASSEMBLY Removal

27. REMOVE NO. 2 AIR CLEANER INLET Removal

28. REMOVE NO. 1 AIR CLEANER INLET Removal

29. REMOVE AIR CLEANER CAP SUB-ASSEMBLY Removal

30. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY Removal

31. REMOVE AIR CLEANER CASE SUB-ASSEMBLY Removal

32. REMOVE AIR CLEANER BRACKET Removal

33. SEPARATE BRAKE MASTER CYLINDER RESERVOIR ASSEMBLY Removal

34. REMOVE RESERVOIR BRACKET Removal

35. REMOVE NO. 2 ENGINE MOUNTING STAY RH Removal

36. REMOVE ENGINE MOVING CONTROL ROD Removal

37. DISCONNECT NO. 1 FUEL VAPOR FEED HOSE Removal

38. DISCONNECT NO. 1 RADIATOR HOSE Removal

39. DISCONNECT NO. 2 RADIATOR HOSE Removal

40. DISCONNECT HEATER WATER HOSE OUTLET B Removal

41. DISCONNECT HEATER WATER HOSE INLET B Removal

42. DISCONNECT FUEL TUBE SUB-ASSEMBLY Removal

43. DISCONNECT OIL COOLER INLET HOSE Removal

44. REMOVE OIL COOLER OUTLET HOSE Removal

45. DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY Removal

46. DISCONNECT ENGINE WIRE Removal

47. DISCONNECT UNION TO CHECK VALVE HOSE Removal

48. REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY (for 4WD) Removal

49. REMOVE TAIL EXHAUST PIPE ASSEMBLY Removal

50. REMOVE CENTER EXHAUST PIPE ASSEMBLY Removal

51. REMOVE NO. 3 FRONT EXHAUST PIPE SUB-ASSEMBLY Removal

52. REMOVE FRONT EXHAUST PIPE ASSEMBLY Removal

53. DISCONNECT FRONT STABILIZER LINK ASSEMBLY LH Removal

54. DISCONNECT FRONT STABILIZER LINK ASSEMBLY RH Removal

55. REMOVE FRONT AXLE HUB NUT LH Removal

56. REMOVE FRONT AXLE HUB NUT RH Removal

57. DISCONNECT FRONT SPEED SENSOR LH Removal

58. DISCONNECT FRONT SPEED SENSOR RH Removal

59. DISCONNECT TIE ROD ASSEMBLY LH Removal

60. DISCONNECT TIE ROD ASSEMBLY RH Removal

61. SEPARATE NO. 1 FRONT SUSPENSION LOWER ARM LH Removal

62. SEPARATE NO. 1 FRONT SUSPENSION LOWER ARM RH Removal

63. SEPARATE FRONT AXLE ASSEMBLY LH Removal

64. SEPARATE FRONT AXLE ASSEMBLY RH Removal

65. DISCONNECT STEERING INTERMEDIATE SHAFT SUB-ASSEMBLY Removal

66. DISCONNECT DISCHARGE HOSE SUB-ASSEMBLY Removal

67. DISCONNECT SUCTION HOSE SUB-ASSEMBLY Removal

68. REMOVE ENGINE ASSEMBLY WITH TRANSAXLE Removal

69. REMOVE V-RIBBED BELT Removal

70. REMOVE FRONT STABILIZER BAR (for 4WD) Removal

71. REMOVE POWER STEERING LINK ASSEMBLY (for 4WD) Removal

72. REMOVE COOLER COMPRESSOR ASSEMBLY Removal

73. REMOVE VENTILATION HOSE Removal

74. REMOVE INTAKE AIR SURGE TANK ASSEMBLY Removal

75. REMOVE ENGINE WIRE Removal

76. REMOVE STARTER ASSEMBLY Removal

77. REMOVE TRANSVERSE ENGINE MOUNTING BRACKET Removal

78. REMOVE MANIFOLD STAY Removal

79. INSTALL ENGINE HANGERS Removal

80. REMOVE FRONT FRAME ASSEMBLY Removal

81. REMOVE FRONT ENGINE MOUNTING INSULATOR ASSEMBLY Removal

82. REMOVE TRANSVERSE ENGINE MOUNTING INSULATOR Removal

83. REMOVE TRANSVERSE ENGINE MOUNTING INSULATOR Removal

84. REMOVE FRONT DRIVE SHAFT ASSEMBLY LH Removal

85. REMOVE FRONT DRIVE SHAFT ASSEMBLY RH (for 4WD) Removal

86. REMOVE NO.2 TRANSMISSION CONTROL CABLE BRACKET Removal

87. REMOVE WIRE HARNESS CLAMP Removal

88. REMOVE WIRE HARNESS Removal

89. DISCONNECT CONNECTORS Removal

90. REMOVE TRANSFER STIFFENER PLATE RH Removal

91. REMOVE AUTOMATIC TRANSAXLE WITH TRANSFER Removal

92. REMOVE NO.1 TRANSFER CASE PLUG

(a) Remove the No. 1 transfer case plug.





(b) Remove the No. 1 gasket from the No. 1 transfer case plug.

93. REMOVE NO.2 TRANSFER CASE PLUG

(a) Remove the No. 2 transfer case plug.

(b) Remove the No. 2 gasket from the No. 2 transfer case plug.

94. REMOVE TRANSFER DRAIN PLUG

(a) Remove the transfer drain plug and bleed the oil.

(b) Remove the drain gasket from the transfer drain plug.

95. REMOVE TRANSFER ASSEMBLY

(a) Remove the 2 bolts and 6 nuts.





(b) Using a plastic hammer, remove the transfer assembly from the transaxle assembly.

NOTICE:
* Remove the transfer assembly from the transaxle assembly without tilting it.
* When removing the transfer assembly, do not hold onto the oil seal parts on both sides of the assembly.