Control Module: Service and Repair

NOTE: The basic setting should be initiated after performing the following repairs:
^ Exchanging engine
^ Replacing engine control module
^ Replacing/altering throttle valve
^ Adjusting throttle valve (setting idling speed).
^ Replacing Throttle Position (TP) Sensor -G69-
^ Altering TP Sensor -G69- setting, e.g. when adjusting closed throttle position switch (engine)
^ Replacing Diesel engine injection pump
^ Changes to control lever, altering setting of residual quantity or maximum speed adjustment screw on diesel engines
^ Replacing Transmission Control module -J217-

Procedure
- Connect Scan Tool VAG 1551 and enter address word "02 Transmission electronics" and advance until "Select function XX" appears in the display.

Rapid data transfer HELP
Select function XX

- Indicated on display:
- Press keys 0 and 4. (The function "Initiating basic setting" is selected with 04).

NOTE: Accelerator Pedal must remain in closed throttle position.

Rapid data transfer Q
04 Basic setting

- Indicated on display:
- Confirm entry with key 0.

Basic setting HELP
Enter display group number XX

- Indicated on display:
- Press keys 0 and 0.
- Confirm entry with key Q.

System in basic setting 0-->

- Indicated on display:
The system is now in the basic setting.
- Depress Accelerator Pedal as far as kick down and hold in this position for 3 seconds.
- Press (arrow) key

Rapid data transfer HELP
Select function XX

- Indicated on display:
Select an additional function or function 06 to end output