Code Control Module (Function 07)
^ All functions previously performed the VAG1551 can also be performed using the VAS5051 tester.
^ If ABS control module (w/EDL) -J104- is coded with 00000, the ABS Warning Light -K47- and ESP Control Lamp -K155- remain constantly lit.
^ If control module does not indicate a coding appropriate for the vehicle, or if control module has been replaced, the ABS control module (w/EDL) -J104- must be coded:
Coding is only possible if a dealership number is stored in the VAG1551 scan tool.
At the beginning of the control module coding, determine the individual engine/transmission codes, vehicle type and M-numbers (optional equipment number).
Before you can code the control module, "Login Procedure" function 11 must be successfully carried out using the VAG1551 Scan Tool (ST).
After the control module is coded, zero adjustment of the Steering Angle Sensor -G85- must be performed before exiting the "Initiating Basic Setting" function 04, display group 001.
Test sequence
^ Connect VAG1551 scan tool and select the control module for brake electronics with ignition switched on (address word 03).
^ Press -> button
Indicated on display
^ Press buttons -1- and -1-. This selects the "Login procedure" function 11.
Indicated on display:
^ Press -Q- button to confirm input.
Indicated on display:
^ Enter login code according to the Login code table:
Login code table
1) Overview of vehicle versions, M-numbers and brake versions (Options equipment number).
1) Overview of vehicle versions, M-numbers and brake versions (Options equipment number).
1) Overview of vehicle versions, M-numbers and brake versions (Options equipment number).
1) Overview of vehicle versions, M-numbers and brake versions (Options equipment number).
1) Overview of vehicle versions, M-numbers and brake versions (Options equipment number).
2) Note the different brake variations with the same Optional equipment number
1) Overview of vehicle versions, M-numbers and brake versions (Options equipment number).
Indicated on display
^ Press buttons -0- and -7- to select "Code Control Module" function 07 and press -Q- button to confirm input.
Indicated on display
^ Press -Q- button to confirm input.
Indicated on display:
^ Enter code according to the Coding table:
Coding table
1) Overview of vehicle versions, M-numbers and brake versions (Options equipment number).
1) Overview of vehicle versions, M-numbers and brake versions (Options equipment number).
1) Overview of vehicle versions, M-numbers and brake versions (Options equipment number).
2) Note the different brake variations with the same Optional equipment number
1) Overview of vehicle versions, M-numbers and brake versions (Options equipment number).
Display will indicate the control module identification and the coding, e.g.:
^ Press -> button
Indicated on display
^ Press buttons -1- and -1-. This selects the "Login procedure" function 11.
Indicated on display:
^ Press -Q- button to confirm input.
Indicated on display:
^ Enter code 40168.
The login code 40168 is reserved for zeroing the Steering Angle Sensor -G85-.
Indicated on display
^ Press buttons -0- and -4- to select the function "Initiate basic setting" for performing the zero adjustment of the Steering Angle Sensor -G85-, display group 001